3
525 Field | Default: NTSC |
Press the 4 button until the cursor is at the 525 label, and press ENTER to move into the field. This field allows selection of the output format for
CAUTION: Change will interrupt service
Press E to continue or 
to stop
Press any arrow button (4) to back out of the field and leave it unchanged, or press ENTER to proceed.
625 Field | Default: |
Press the 4 button until the cursor is at the 625 label, and press ENTER to move into the field. This field allows selection of the output format for
CAUTION: Change will interrupt service
Press E to continue or 
to stop
Press any arrow button (4) to back out of the field and leave it unchanged, or press ENTER to proceed.
Firmware Menu
Press the buttons until the Firmware menu appears. This menu displays the unit's firmware release information, which is equivalent to the product version number. This menu cannot be changed, but since the firmware is periodically updated, this menu confirms that the update was successful. This menu is used most commonly in troubleshooting. The High version value (shown below) is the current firmware version.
FIRMWARE Boot:FPGA:High Upgrade
E XXXXXX:XXXXXX:XXXXX 000000
Boot:FPGA:High Field
This field displays the version of boot, FPGA, and the high code. The boot code is loaded at the factory. The FPGA and high codes may be upgraded to later versions by a download that is delivered over the satellite signal from either the
48
