Motorola i860 manual Technician Test Procedures, Programming the i 860 Unit

BASIC LEVEL TEST MODES AND PROCEDURES: Technician Test Procedures

28.Scroll down to highlight Hardware, and then press OK to view the Hardware display. This screen displays RF Xtal (RF Crystal), a factory-tuned parameter that adjusts the output frequency; Xtal Offset (RF Crystal Warp offset), which is derived during frequency compensation; and Level Set (Level Set value), which regulates the transmit output power of the unit.

29.Press Back to return to the Trace Mode display.

30.Scroll down to highlight Fatal Err/#, and then press OK to view the Fatal Err/# display. This screen displays the Fatal Error log. This log contains a count of any fatal errors logged during the unit's automatic self test.

31.Press Back to return to the Trace Mode display.

32.Scroll down to highlight Flags, and then press OK to view the Flags display. This screen displays the error log, which contains any errors logged by the unit software.

33.Press Back to return to the Trace Mode display.

34.Scroll down to highlight Coin Cell, and then press OK to show the Preset Charging Voltage on line 1 and Current Battery Voltage on line 2.

35.Press Back to return to the Trace Mode display.

36.Scroll down to highlight CE Status, and then press OK to view accessory type connected to the unit.

37.Press Back to return to the Trace Mode display.

6.3Technician Test Procedures

Technician tests usually require special equipment to test the functionality of the components in the unit.

The following tests check the software functionality of the unit:

•Codeplug Repair Procedure

•Codeplug Troubleshooting

•Corrupted Software Repair Procedure

6.4Programming the i 860 Unit

Use Radio Service Software (RSS) to program a new software version or to program codeplug user information. Refer to the Radio Service Software User’s Guide for information on the setup and use of RSS.

6-8 68P80400P73-A