Manual
NOTE The PTZ control protocol is not standardized. To use a particular PTZ control protocol, the video server must support the driver for that protocol. Currently, the VPort 351 supports PTZ control protocol drivers for:
1.Pelco D
2.Pelco P
3.DynaColor DynaDome
If you need to use a protocol that is not on the list, you will need to contact the manufacturer of the camera to get the PTZ control commands, and then program its PTZ control in the VPort 351’s Custom Camera function.
NOTE The VPort 351 comes with a PTZ driver upload function for implementing new PTZ drivers. Please contact a Moxa sales representative if you need assistance from Moxa’s R&D department to create a new PTZ driver.
NOTE The “Transparent PTZ Control” function in the camera driver list is used to transmit the PTZ control signal over a TCP/IP network to the VPort D351 video decoder or PC (additional driver required). The PTZ control panel or keyboard can directly control the PTZ camera or device, eliminating the need for a PTZ camera driver and allowing the use of PTZ cameras with the VPort encoder.
Step 5: Configure the VPort 351’s IP address
After powering on the VPort 351, wait a few seconds for the POST (Power On Self Test) to run. The STAT LED turns green to indicate that the POST process has completed. The IP address will be assigned when the 10 or 100 Mbps NETWORK LED blinks. The IP address assigned after the POST is completed depends on the network environment.
Network Environment with DHCP Server
In this case, the IP address of the VPort 351 is assigned by a DHCP Server. Use the DHCP Server’s IP address table, or use the Moxa VPort utility to determine the IP address that was assigned by the DHCP Server.
NOTE After powering on the VPort 351, wait a few seconds for the POST (Power On Self Test) to run. The IP address will be assigned when the 10 or 100 Mbps NETWORK LED blinks.
Using the Moxa VPort and EtherDevice Configurator Utility (edscfgui.exe)
1.Run the edscfgui.exe program to search for VPorts and EDS switches. After the Utility window opens, select or click on Broadcast Search
(under the List Server menu or click on Broadcast Search icon 
) to initiate a search.
-6 -
Amplicon.co.uk | IT and Instrumentation for industry |
Sales: +44 (0) 1273 570 220 Website: www.amplicon.co.uk Email: sales@amplicon.co.uk
