Multiquip operation manual DCA-15SPX3 PRE-SETUP, General Inspection Prior to Operation

DCA-15SPX3 — PRE-SETUP

General Inspection Prior to Operation

The DCA-15SPX3 generator has been thoroughly inspected and accepted prior to shipment from the factory. However, be sure to check for damaged parts or components, or loose nuts and bolts, which could have occurred in transit.

Extension Cable

When electric power is to be provided to various tools or loads at some distance from the generator, extension cords are normally used. Cables should be sized to allow for distance in length and amperage so that the voltage drop between the generator and point of use (load) is held to a minimum. Use Table 6 (cable selection guide) as a guide for selecting proper cable size.

Circuit Breaker

To protect the generator from an overload, a 3-pole, 65 amp, main circuit breaker is provided to protect the UNV output from overload. In addition a 2-pole, 20 amp GFCI circuit breaker is provided to protect the GFCI receptacle from overload. Make sure to switch both circuit breakers to the "OFF" position prior to starting the engine.

NOTE

ALWAYS consult with a licensed electrician for correct extension cord wire size.

Table 6. Cable Selection (60 Hz, Single Phase Operation)

	Load In Watts			Maximum Allowable Cable Length
Current in
	At 120	At 240
Amperes			#10 Wire		#12 Wire	#14 Wire	#16 Wire
	Volts	Volts
2.5	300	600	1000 ft.		600 ft.	375 ft.	250 ft.
5	600	1200	500 ft.		300 ft.	200 ft.	125 ft.
7.5	900	1800	350 ft.		200 ft.	125 ft.	100 ft.
10	1200	2400	250 ft.		150 ft.	100 ft.
15	1800	3600	150 ft.		100 ft.	65 ft.
20	2400	4800	125 ft.		75 ft.	50 ft.
CAUTION: Equipment damage can result from low voltage.

PAGE 32 — DCA-15SPX3 GENERATOR— PARTS & OPERATION MANUAL — REV. #2 (09/03/01)