DCA-25SSI — OUTPUT VOLTAGE SETUP
Voltage Selector Switch- 3 Phase 240/139V Position The following are additional voltages available when the voltage selector switch is in the 3 phase 240/139V position.
Single Phase: 240V, 220V, or 208 Volt
This setting can provide single phase power at 240, 220, or 208 volts. After hooking up the hard wires to the lugs as shown in Figure 25, 240 volts can be obtained the voltage regulator knob turned toward maximum; 220 volts can be obtained with the voltage regulator knob is turned down; and 208 volts can be obtained with the voltage regulator knob is at lowest setting.
Figure 25. Hard Wire Hookup for Single Phase 240V, 220V,
FIGURE 23. Voltage Selector Switch 240/139V Three Phaseor 208V Position
3 Phase, 240V, 220V, or 208 Volt
This setting can provide
Single Phase: 139V, 127V, or 120V
This setting can provide single phase power at 139, 127, or 120 volts. After hooking up the hard wires to the lugs as shown in Figure 26, 139 volts can be obtained the voltage regulator knob turned toward maximum; 127 volts can be obtained with the voltage regulator knob is turned down; and 120 volts can be obtained with the voltage regulator knob is at lowest setting.
Figure 24. Hard Wire Hookup for Three Phase 240V, 220V, or | Figure 26. Hard Wire Hookup for Single Phase 139V, 127V, | |
or 120V | ||
208V | ||
| ||
| ||
PAGE 34 — | ||
|
| |
