Multiquip DCA-60SS12 operation manual DCA-60SSI2— CONTROL PANEL

DCA-60SSI2 — CONTROL PANEL

The definitions below describe the controls and functions of the DCA-60SSI2 " Control Panel " (Figure 8).

1.Frequency Meter – Indicates the output frequency in hertz (Hz). Normally 60 Hz ±1 Hz .

2.AC Ammeter – Indicates the amount of current the load is drawing from the generator.

3.ACVoltmeter – Indicates the single phase output voltage present at the UNV terminals.

4.Pilot Lamp - This lamp indicates the load is not properly set. Readjust the load, or use the voltmeter change- over switch to adjust phase position.

5.Main Circuit Breaker – This three-pole, 150 amp main breaker is provided to protect the UNV voltage output terminals from overload.

6.Voltmeter Change-Over Switch – This switch allows the AC voltmeter to indicate phase to phase voltage between any two phases of the output terminals or to be switched off.

7.Ammeter Change-Over Switch – This switch allows the AC ammeter to indicate the current flowing to the load connected to any phase of the output terminals, or to be switched off.

8.Voltage Regulator Control – Allows manual adjustment of the generator’s output voltage.

DCA-60SSI2 — PARTS AND OPERATION MANUAL— REV. #3 (09/15/01) — PAGE 29