Blade Safety | Multiquip Sp-6065 guide

BLADE SAFETY

WARNING

§ALWAYS inspect diamond blades before each use. The blade should exhibit no cracks, dings, or flaws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.

§Examine blade flanges for damage, excessive wear and cleanliness before mounting blade. Blade should fit snugly on the shaft and against the inside/outside of the saw.

§Only cut the material that is specified by the blade. Read the specifications of the blade to ensure the proper tool has been matched to the material being cut.

§ALWAYS keep blade guards in place. Exposure of the blade must not exceed 180 degrees.

§Ensure that the blade does not come into contact with the ground or surface during transportation. DO NOT drop the blade on the ground or surface.

§The engine governor is designed to permit maximum engine speed in a no-load condition. Speeds that exceed this limit may cause the blade to exceed the maximum safe allowable speed.

§Ensure that the blade is mounted for proper operating direction.

14

Image 14

Multiquip Sp-6065 operation manual Blade Safety

Contents

SP-6065 Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard General Safety Warnings Rules for Safe OperationPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Serial Tag Model no SPEC. no Serial no Serial TAG Operation Before Starting Engine Power, Cutting Power & Sheave Size Blade Shaft Ratios 18600 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Stacking Blades for Wide Cuts Blade Stacking Installing and Removing the Blade Guard Installing the Blade Guard Blade Guard Water Supply Installing the Collar Guard Collar Guard, Installed Water Supply and Control Water Supply System Control Panel ON-OFF Handlebars Handlebar Positions Similar to illustration Fueling the Saw Fuel System ON/OFF Switch, Choke, Throttle Locations Starting and Stopping the Engine Draining the Water System Pointer AdjustmentBlock Heaters Pointer Adjustment Setting the Depth Indicator Raise Lower Controls Setting the Depth Stop Drive System Drive System Controls Transaxle Transaxle Tie-downs Night LightTransportation Tie-downs and Lift Point Lift Point Lift Point Maintenance Removable Guards and Access Panels Belts and Pulleys Belt Tension Adjusting Blade Shaft Drive Belt Tension Engine Mount Lock Bolts Replacing the Blade Shaft Belt Replacing the Jackshaft Belt Rotary Belt Tensioner Do not OVER-TIGHTEN Blade Shaft Maintenance Blade Shaft Replacement Blade Collar Removal/Installation Removing the Inner Blade Collar Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Maximum Cut Depth Adjustment Circuit Breakers Lubrication Air and Oil Filter Chart Engine PTO Drive Maintenance Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Sheave/Bearing Assembly Re-Assembling the PTO Drive Replacing the Battery Rotate Engine Forward to Remove the Battery Raise/Lower Troubleshooting Raise-Lower System Joystick Tension Adjustment Joystick Adjustment Hydraulic System Maintenance Routine Maintenance Draining & Filling the Hydraulic System To drain the hydraulic system To fill the hydraulic system with oil Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions and Weights Www multiquip.com