Table of Contents | Multiquip Sp-6065 manual

TABLE OF CONTENTS

CONVENTIONS	3
SAFETY	7
OPERATION	19
BEFORE STARTING	19
ENGINE POWER, CUTTING POWER & SHEAVE SIZE	20
Blade RPM vs Surface Feet Per Minute (SFPM)	......................................................22
Installing the Blade	24
Stacking Blades for Wide Cuts	24
Installing and Removing the Blade Guard	26
Installing the Collar Guard	27
WATER SUPPLY AND CONTROL ………………………………………………………..28
CONTROL PANEL	29
HANDLEBARS	30
FUELING THE SAW	31
STARTING AND STOPPING THE ENGINE	32
COLD WEATHER OPERATION	ERROR! BOOKMARK NOT DEFINED.
Glow Plugs	Error! Bookmark not defined.
Block Heaters	33
Draining the Water System	33
POINTER ADJUSTMENT	33
RAISE — LOWER CONTROLS	35
SETTING THE DEPTH INDICATOR	35
SETTING THE DEPTH STOP……………………………………………………………..36
DRIVE SYSTEM	37
Transaxle	38
NIGHT LIGHT	39
TRANSPORTATION TIE-DOWNSAND LIFT POINT	39
Tie-Downs	40
Lift Point	41

5

Image 5

Multiquip Sp-6065 operation manual Table of Contents

Contents

SP-6065 Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial Tag Serial TAG Before Starting Operation Blade Shaft Ratios Engine Power, Cutting Power & Sheave Size 18600 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Blade Stacking Stacking Blades for Wide Cuts Installing the Blade Guard Installing and Removing the Blade Guard Blade Guard Water Supply Collar Guard, Installed Installing the Collar Guard Water Supply System Water Supply and Control ON-OFF Control Panel Handlebar Positions Similar to illustration Handlebars Fuel System Fueling the Saw Starting and Stopping the Engine ON/OFF Switch, Choke, Throttle Locations Draining the Water System Pointer AdjustmentBlock Heaters Pointer Adjustment Raise Lower Controls Setting the Depth Indicator Setting the Depth Stop Drive System Controls Drive System Transaxle Transaxle Tie-downs Night LightTransportation Tie-downs and Lift Point Lift Point Lift Point Removable Guards and Access Panels Maintenance Belt Tension Belts and Pulleys Engine Mount Lock Bolts Adjusting Blade Shaft Drive Belt Tension Replacing the Jackshaft Belt Replacing the Blade Shaft Belt Do not OVER-TIGHTEN Rotary Belt Tensioner Blade Shaft Replacement Blade Shaft Maintenance Removing the Inner Blade Collar Blade Collar Removal/Installation Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Circuit Breakers Maximum Cut Depth Adjustment Lubrication Engine Air and Oil Filter Chart Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Maintenance Re-Assembling the PTO Drive PTO Drive Sheave/Bearing Assembly Rotate Engine Forward to Remove the Battery Replacing the Battery Raise-Lower System Raise/Lower Troubleshooting Joystick Adjustment Joystick Tension Adjustment Routine Maintenance Hydraulic System Maintenance To drain the hydraulic system Draining & Filling the Hydraulic System To fill the hydraulic system with oil Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions and Weights Www multiquip.com