64
SPECIFICATIONS
Engine 57 HP Turbocharged Deutz Diesel, direct injection, air/oil cooling, oil filter and
above-frame remote oil drain.
Engine Air Cleaner 4-Stage air filtration, pre-cleaner plus cartridge element and safety element.
Fuel Tank 10 Gallon clear-molded plastic fuel tank with sight gauge, central drain and
shutoff valve.
Blade Shaft Assembly Fully enclosed bearings and shaft, oil bath lubrication, 2-3/8” diameter shaft,
magnetic drain plug, seal protectors and protected remote oil fill and vent.
Blade Collars Plated quick-disconnect, taper lock attachment, 5.5” diam., 24 water spray ports.
Blade Flushing Minimum water usage system, evenly distributed across the blade, panel-
mounted flow control.
Blade Range 14” to 36”.
Max Cut Depth 15”.
Blade Guard Extra heavy design, slip-on type with double lip seal and quick disconnect water
hose, two handles.
Blade Shaft Drive Belt Dual 5--Groove 3VX530 Powerband.
Blade Control 12-Volt hydraulic raise/lower system, 3 blade plunge speeds, fast and slow blade
plunge speed buttons on joystick, raise button on joystick, one-hand control.
Blade Depth Stop Positive, heavy-duty hydraulically controlled depth stop.
Balance Front steer.
Handlebars 3-Position adjustable angle, storage position, quick locks.
Front Wheels 8” x 3”, precision sealed bearings in each wheel with extra end seals and seal
protectors, no grease points.
Rear Wheels 12” x 3”.
Drive System Hydrostatic powered transaxle with infinite speed control, joystick control, remote
oil filter and up to 300 feet per minute travel speed. Locked axle drive.
Engine Controls Twist-lock throttle, backlit tachometer with hour meter, voltmeter, oil pressure
gauge and 3-position ignition switch.
Battery 12-Volt, group 75, 1000 cold cranking amps.
Front Pointer Heavy gauge steel, 6” pointer wheel and plastic-coated tether.
Rear Pointer Standard, adjustable.
Hardware Grade 8 fasteners throughout.
Tools 15/16” Blade wrench.
Dimensions L= 47-1/2” with handlebars stored, W = 32” w/o blade collars, H= 44” with front
pointer up.
Weight Approx. 1,500 Pounds, with oil but no fuel. (Actual weight depends on blade
guard used.)
Serviceability Spin-on oil filters, lubrication points, lube every 50 hours.