28
Water Supply and Control
CAUTION
§ To prevent damage to the impeller of a belt driven water pump, do
not run the engine with the water pump switch on, unless the
water supply is connected and water is flowing.
§ When storing the saw during freezing weather, blow out the water
lines to prevent damage to the water delivery system.
1. Connect the water supply hose to the water inlet (garden hose) fitting (1) on
the left side of the saw.
2. Verify that the water hose on the saw is connected to the Blade Guard (5) and
that the water tubes are pointed into both Blade Collars.
3. The yellow lever (4) on left side of the control panel regulates water flow
volume. The other lever (3) turns the water On and Off.
4. If the saw is equipped with an optional water pump, the ON/OFF switch (2)
is on the control panel next to the water flow control valve.
!
NOTE
Because of the water delivery efficiency of the 24-port blade collars,
your saw will use less water for blade lubrication than other water
deliver systems.
Fig. 10 — The Water Supply System
1
2
3
4
5