Rules for Safe Operation | Multiquip Sp-6065 instruction

RULES FOR SAFE OPERATION

Most accidents involving product operation, maintenance and repair are caused by failure to observe basic safety rules and precautions. Accidents can often be avoided by recognizing potentially hazardous situations before an incident occurs.

General Safety Warnings

WARNING

§DO NOT operate or service this equipment before reading this entire manual. Failure to follow instructions may lead to serious injury or death.

§This equipment is to be operated by trained and qualified personnel only. This equipment should not be operated by persons under 18 years of age.

§This equipment is for industrial use and to be used for its intended purpose only.

§NEVER operate this equipment when not feeling well due to fatigue, illness or taking medicine.

§NEVER operate the saw under the influence of drugs or alcohol.

§NEVER use accessories or attachments, which are not recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result. Manufacturer does not assume responsibility for any accident due to equipment modifications. Unauthorized equipment modification will void all warranties.

§NEVER operate this saw without proper protective clothing; shatterproof glasses, steel-toed boots, respiration mask, and any other protective devices required by the job.

11

Image 11

Multiquip Sp-6065 operation manual Rules for Safe Operation, General Safety Warnings

Contents

SP-6065 Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial Tag Serial TAG Before Starting Operation Blade Shaft Ratios Engine Power, Cutting Power & Sheave Size 18600 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the Blade Blade Stacking Stacking Blades for Wide Cuts Installing the Blade Guard Installing and Removing the Blade Guard Blade Guard Water Supply Collar Guard, Installed Installing the Collar Guard Water Supply System Water Supply and Control ON-OFF Control Panel Handlebar Positions Similar to illustration Handlebars Fuel System Fueling the Saw Starting and Stopping the Engine ON/OFF Switch, Choke, Throttle Locations Draining the Water System Pointer AdjustmentBlock Heaters Pointer Adjustment Raise Lower Controls Setting the Depth Indicator Setting the Depth Stop Drive System Controls Drive System Transaxle Transaxle Tie-downs Night LightTransportation Tie-downs and Lift Point Lift Point Lift Point Removable Guards and Access Panels Maintenance Belt Tension Belts and Pulleys Engine Mount Lock Bolts Adjusting Blade Shaft Drive Belt Tension Replacing the Jackshaft Belt Replacing the Blade Shaft Belt Do not OVER-TIGHTEN Rotary Belt Tensioner Blade Shaft Replacement Blade Shaft Maintenance Removing the Inner Blade Collar Blade Collar Removal/Installation Installing the Inner Blade Collar Installing the Inner Blade Collar Inner Collar Blade Shaft Circuit Breakers Maximum Cut Depth Adjustment Lubrication Engine Air and Oil Filter Chart Attaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive Maintenance Re-Assembling the PTO Drive PTO Drive Sheave/Bearing Assembly Rotate Engine Forward to Remove the Battery Replacing the Battery Raise-Lower System Raise/Lower Troubleshooting Joystick Adjustment Joystick Tension Adjustment Routine Maintenance Hydraulic System Maintenance To drain the hydraulic system Draining & Filling the Hydraulic System To fill the hydraulic system with oil Bleeding the Depth Stop Cylinder Bleeding the Depth Stop Cylinder Drive Wheel Alignment Drive Wheel Alignment Pivot Side Adjustment Side Specifications Dimensions and Weights Www multiquip.com