25
GENERAL MAINTENANCE NPS40 AND NPI40
DAILY (WHENEVER USING THE HEATER)
OPEN MAIN VIEWING DOOR
!WARNING
The front of the heater becomes very hot during opera- tion. Let the heater cool completely before conducting service.
1.Open the side doors on either side of the heater.
Figure 35
2.On the right side of the heater are two latches. Release the latches by pulling the rear handle forward and dis- engaging the hook from the door frame. Swing open the viewing door.
INSPECT THE BURN POT
When burning, the fl ames should be bright orange with embers jumping from the burn pot.
Figure 37
CLEANING GLASS DOOR
If the glass is not kept clean, permanent discolouration and/or blemishes may result. If glass should ever crack, it must be replaced using 5mm thick ceramic glass available from your Napo- leon Dealer.
DO NOT SUBSTITUTE MATERIALS
DO NOT CLEAN GLASS WHEN HOT
DO NOT use abrasive cleaners to clean glass or plated parts.
DO NOT OPERATE THIS HEATER WITH THE GLASS DOOR OPEN
CLEANING THE HEAT EXCHANGE TUBES
Figure 36
DISPOSAL OF ASHES
Ashes should be placed in a metal container with a tight fi tting lid. The container should be placed on a
!WARNING
The front edge of the hopper lid becomes very hot, do not touch the area below the handle.
Figure 40
!WARNING
This rod becomes very hot during operation. Wait till heat- er has cooled completely or you MUST wear heat resistant gloves when cleaning or handling this heater.
With the heater cool (or wearing heat resistant gloves), slide the heat exchange cleaner rod up and down several times to prevent the build up of ash on the heat exchange tubes.
Keep the viewing door closed so the fl y ash does not enter the room.
NOTE: More frequent cleaning may be required depending upon pellet quality.
