The Standalone Diagnostic Package Configuration Diskette allows the following
to be changed from the console:
Default refresh rate for a LFT
The refresh rate used by the standalone diagnostic package is 60Hz. If the
display's refresh rate is 77Hz, then set the refresh rate to 77.
Different async terminal console
A console configuration file that allows a terminal attached to any RS232 or
RS422 adapter to be selected as a console device can be created using this
service aid. The default device is a RS232 tty attached to the first standard
serial port (S1).
Delete Resource from Resource List
Use this task to delete resources from the resource list.
Note: Only resources that were previously detected by the diagnostics and have not
been deleted from the Diagnostic Test List are listed. If no resources are available
to be deleted, then none are listed.
Disk Maintenance
Disk to Disk Copy
Display/Alter Sector
Disk to Disk Copy
Notes:
1. This service aid cannot be used to update to a different size drive. The service
aid only supports copying from a SCSI drive to another SCSI drive of similar
size.
2. Use the migratepv command when copying the contents to other disk drive
types. This command also works when copying SCSI disk drives or when
copying to a different size SCSI disk drive. Refer to

System Management Guide:

Operating System and Devices

for a procedure on migrating the contents of a
physical volume.
This selection allows you to recover data from an old drive when replacing it with a
new drive. The service aid recovers all LVM software reassigned blocks. To prevent
corrupted data from being copied to the new drive, the service aid aborts if an
unrecoverable read error is detected. To help prevent possible problems with the
9-12 7046 Model B50 User's Guide