Chapter 2. Using the Server
This section provides information on how to start and use the server.
Starting the Server
Perform the following steps to start the server.
1.Turn on all attached devices.
2.Turn on the server.
3. If power | does | not come | on | when | you turn on | the | server, | ensure | that | the po | |||||||
cord, | located | at the back of the server, | is plugged in. If this does not | ||||||||||||||
problem, | go | to | Chapter 8, | “Determining | Hardware | Problems.” |
|
|
|
| |||||||
When | you | turn | on | the server, the Power LED comes | on | and | the | server | starts a | ||||||||
POST | test). | During | this | test, the | disk status LED flashes intermitten | ||||||||||||
The | server | beeps | a | short | beep, and | progress | indicators | appear on | the | operator | |||||||
panel | display | (if | a | display | is | attached). |
|
|
|
|
|
|
|
Copyright IBM Corp. 1999 |