Press Enter when you are finished; you must type the password again for
verification.
If you type the password incorrectly, press Esc and start again.
After you have entered and verified the password, the power-on password status
icon flashes and changes to the locked position to indicate that the power-on
password is installed.
If you previously had set a power-on password and want to remove it, select the
Remove icon.
Notes:
1. If you want to disable an installed power-on password (but not erase it), move
the power-on password jumper as described in the section beginning on page
4-8. Moving the jumper back to the default position re-enables the power-on
password, unless it has been removed in the System Management Services
Utilities or by removing the battery.
2. If you
forget
the power-on password, you can erase the password by shutting
down the server and removing the battery for at least 30 seconds. See
“Changing the Battery” on page 4-36 for details.
3. The server power cable
must
be disconnected before removing the battery.
A password becomes effective only after the server is turned off and back on again.
3-12 7046 Model B50 User's Guide