6
GENERAL INTRODUCTION
GENERAL INSTRUCTIONS
Thank you for purchasing the Napoleon® Pellet Heater.
This heater is designed for use with Pelletized Wood Only.
Please read this entire manual before installation and use of this pellet
Keep this manual handy for future reference.
This Pellet Heater, when installed, must be electrically grounded in accordance with the local codes, or in the absence of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70 National Electrical Code in the United States.
This heater will not operate using natural draft or without a power source for the blower systems and fuel feed system.
PELLET QUALITY
Pellet quality is important, please read the following:
Your Napoleon® Pellet Heater has been designed to burn premium hard or soft wood pellets only. Do not use any other type of fuel such as fire logs or fire starting pellet, as this will void the warranties stated in this manual.
The performance and heat output of the pellet heater is directly related to the quality and moisture of the pellets.
Store pellets in a cool dry area to prevent moisture absorption.
CAUTION: It is important to select and use only pellets that are dry and free of dirt or any impurities such as high salt content. Dirty fuel will adversely affect the operation and performance of the unit and will void the warranty. The Pellet Fuel Industries (P.F.I.) has estab- lished standards for wood pellet manufacturers. We recommend the use of pellets that meet or exceed these standards. Ask your dealer for a recommended pellet type.
P.F.I. PELLET STANDARDS:
Fines (fi ne particles) | 1% maximum through a 1/8" screen |
Bulk Density | 40 pound per cubic foot minimum |
Size | 1/4" to 5/16" diameter, 1/2" - 1 1/2" long maximum |
Ash Content | 1% maximum (Premium grade) |
| 3% maximum (Standard grade) |
Moisture Content | 8% maximum |
Heat Content | Approximately 8200 BTU per pound minimum |
If the fuel does not comply to this standard the unit may not operate as designed.
We recommend the use of premium grade (1% ash content) for longer stove life and less frequent cleaning.
SPECIFICATIONS
HEATING SPECIFICATIONS
Approximate Maximum Heating Capacity (in square feet)* | 800 to 2000 Sq. Feet | |
Burn Rate (Pounds per Hour)** | 1.0 to 5.0 | |
Maximum Burn Time on Low Burn** | 55 | Hours (NPS40), 45 Hours (NPI40) |
Hopper Capacity | 55 | Pounds (NPS40), 45 Pounds (NPI40) |
* Heating capacity will vary depending on the home's fl oor plan, degree of insulation, and the outside temperature. It is also af- fected by the fuel size, quality, and moisture level.
** Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on fuel quality may occur.
