NCR RealScan 7882 Installation and Owner Guide
Programming Defaults
Scanning the Default programming tag sets most program parameters to factory defined values as shown in the following chart. However, some parameters do not have default values so they are not changed, they stay as they are programmed.
01 Communications Protocol |
|
Protocol | No default value – remains as programmed |
|
|
11 Good Read Tone |
|
Tone On/Off | On |
Tone Frequency | Choice 6 of 8 Levels |
Tone Length | Choice 3 of 16 Levels |
Tone Volume | Choice 4 of 8 Levels |
Choice 2 of 8 Levels | |
|
|
12 Timers |
|
Lockout Time | 750 Milliseconds |
Restart Lockout Timer | Off |
Active Time | 15 Minutes |
|
|
13 Bar Codes – 1 |
|
UPC/EAN | Enable |
Version D | Disable |
Extend | Disable |
Extend | Disable |
Periodical Codes | Disable |
Periodical Code Extension | |
Send Data | Data As Decoded |
|
|
14 Bar Codes – 2 |
|
Code 39 | Disable |
Minimum Characters Allowed | 8 |
Full ASCII | Disable |
Check Digit Present | Disable |
Transmit Check Digit | Disable |
Allow 1- or | Disable |
|
|
15 Bar Codes – 3 |
|
Interleaved 2 of 5 | Disable |
Bar Code Length | Range Check |
Value 1 | 08 |
Value 2 | 16 |
Check Digit Present | Disable |
Transmit Check Digit | Disable |
|
|
17 Bar Codes – 4 |
|
Code 128 | Disable |
Minimum Data Characters | 3 |
UCC 128 | Disable |
|
|
14 of 62 | 09/02 |
