Chapter 4 Functions of ReplicationControl
150
(ix) When an LVM volume group or a VxVM disk group is specified, the target volume group or disk
group must be active (UNIX only).
(x) When specifying the combination of an LVM volume group or a VxVM disk group with a special
file name (logical disk name), you must specify the same number of logical volumes that make up
the volume group or disk group as MV (RV) on the special file name (logical disk name) side.
In this case, Copy is performed in specified sequential order (UNIX only).
The above execution conditions (ii), (iii), (vii), (viii), (ix), and (x) are not applicable when conducting a
joint operation with the iSM (replication management).
Figure 4-27 illustrates the execution conditions of Separate.
Figure 4-27 Execution Conditions of Separate
Target Pair
MV RV
(i) Pair setting
(ii) MV or RV has been registered in the volume
list.
(iii) The volume list is not being created or
updated.
(iv) MV has been flushed or unmounted.
(v) Disk array is not in the Freeze state.
(vi) Not in the Restore operation
(vii) The disk is not a dynamic disk or
G
PT-f
o
rm
atted
pa
r
t
i
t
i
o
n
d
i
s
k.