Chapter 3 Replication Management
45
Figure 3-9 shows an example of the Pair Setting Screen.
Figure 3-9 Example of Pair Setting Screen
After the Pair Setting, the copy operation such as Replicate, Restore etc. is available.
(i) Data Replication Mode
Select the method of setting pairs.
Radio Button Description
Dynamic Data Replication (within a Disk
Array)
MV and RV use the volumes in the same Disk
Array.
Remote Data Replication (between Disk
Arrays)
MV and RV use the volumes in different Disk
Arrays.
(ii) Disk Array Name
On the MV part, displays the disk array name with the selected volume.
On the RV part, displays the disk array name for which pair setting of remote data replication
can be performed.
(iii) Object
To make only the selected volume the object of MV, check this (default).
To make all the volumes that can be used as MV the objects, uncheck this.
(iv) LD Set Name
You can narrow down object volumes for which pair setting can be performed by the LD Set
Name.
When the object volume for which pair setting can be performed is not registered in the LD
Set, LD Set Name cannot be used for narrowing down nor selected.
(i)
(ii)
(iii)
(iv)
(v)