Chapter 3 Replication Management
67
[Execution Conditions]
To perform operations of suspending/resuming copy, the following conditions must be satisfied.
(i) The target MV is recognized by Replication Management as the Replication target disk.
(ii) The target MV and RV are paired.
(iii) The activity state of the target pair is Replicate or Restore.
(iv) The Semi-synchronous Copy mode cannot be specified for pairs set in the same disk array.
The Semi-synchronous Copy mode can be specified only for pairs set in different disk arrays. (Can
be set only when copy is resumed.)
(v) The disk array where the specified MV and RV are stored is not in the Freeze state.
(vi) The disk array where the specified MV and RV are stored is monitored.
(In case of copy suspend, MV must be monitored)
(vii) The specified MV is not registered in the AT-group.
Figure 3-25 illustrates the execution conditions of operations of suspending/resuming copy. (Each of
(i) to (vii) in the figure corresponds to the respective number above.)
Figure 3-25 Execution Conditions of Suspend Copy and Resume Copy State Operation
Target Pair
MV
RV
(i) Replication Target Disk
(ii) Pair Setting
(iii) Replicate or Restore
(iv) Semi-synchronous not allowed
for the same disk array
(v) Not in the Free ze state
(vi) Disk array monitored
(vii) The specified MV is not
registered in the AT-group.