Chapter 4 Functions of ReplicationControl
167
Previous Active prev_state
Description
special_file_name: Special file name
ld_name: Logical disk name
type: OS type
activity: Activity State
sync: Paired operation state
copy: Copy Control State
<state> Start Time: Operation start time (<state> varies)
<state> End Time: Operation end time (<state> varies)
separate_diffsize: Difference of copy occurred in the Separate state
copy_diffsize: Difference of copy occurred in the Replicate or Restore state
rvacc: Access restrictions for RV
prev_state: Paired operation state before the state transition
[Execution Conditions]
To perform state display, the following conditions must be satisfied.
(i) The target MV and RV are paired.
(ii) The target MV or RV has been registered in the volume list.
(iii) The volume list is not being created or updated.
(iv) Specifying a volume of a dynamic disk or a GPT-format partition disk is not allowed (Windows
only).
(v) The iSM dedicated special file is not being created (HP-UX version UNIX only).
(vi) When an LVM volume group or a VxVM disk group is specified, the target volume group or disk
group must be active (UNIX only).
(vii) When specifying the combination of an LVM volume group or a VxVM disk group with a special
file name (logical disk name), you must specify the same number of logical volumes that make up
the volume group or disk group as MV (RV) on the special file name (logical disk name) side.
In this case, Copy is performed in specified sequential order (UNIX only).
The above execution conditions except for (i) are not applicable when conducting a joint operation with
the iSM (replication management).
Figure 4-31 shows execution conditions for displaying the replication state.