NEC MT1060 Setting the function switch, Turning off the Projector, To turn off the projector

Setting the function switch

There are two switches on the bottom of the battery case: an applicable projector selector switch (1) and laser enable/disable switch (2). Check the projector being used and decide whether to enable or disable laser, then set these switches as necessary using the tip of a thin ball-point pen. On this model, an applicable projector selector switch (1) is not used.

	OFF ON
Switch (2)
On:	Enabled (the laser lights when the LASER button is pressed)
	[Factory default]
Off:	Disabled (the laser does not light even when the LASER but-
	ton is pressed)

Disable the laser when using in an environment in which the unit is accessible to children.

Turning off the Projector

To turn off the projector:

First press the POWER (ON/STAND BY) but- ton on the projector cabinet or the POWER OFF button on the remote control for a minimum of two seconds. The power indicator will glow or- ange. After the projector turns off, the cooling fans keep operating for 90 seconds (Cooling- off time).

Second, turn off the Main Power switch. The power indicator will go out. Last unplug the power cable.

CAUTION

Do not unplug the power cable from the wall outlet or do not turn off the main power under any one of the following circum- stances. Doing so can cause damage to the projector:

•While the Hour Glass icon appears.

•While the message "Please wait a mo- ment." appears. This message will be displayed after the projector is turned off.

•While the cooling fans are running. (The cooling fans continue to work for 90 sec- onds after the projector is turned off).

•While accessing a PC card. (The PC Card Access indicator lights.)

OFF	ON
	POWER
VIDEO	RGB VIEWER
AUTO ADJ.	LASER

ASPECT	FREEZE 3D REFORM
HELP	POINTER	PIC-MUTE
VOLUME	MAGNIFY	SLIDE
ZOOM	FOCUS	FOLDER
		SLIDE
		LIST

E-23