WEP (for Wireless only)
Select this option whether using the WEP (Wired Equivalent Privacy) key for encryption or not. To use encryption, specify WEP key.
Disable | Will not turn on the encryption feature. Your commu- |
| nications may be monitored by someone. |
64bit | Uses |
128bit | Uses |
| option will increase privacy and security when com- |
| pared to use of 64bit datalength encryption. |
NOTE: The WEP settings must be the same as communication devices such as PC or access point in your wireless network. When you use WEP, your image transmission speed will slow down.
Key Select:
Selects one key from the four keys below when selecing [64bit] or [128bit] in [WEP].
Enter encryption key when selecting [64bit] or [128bit] in [WEP]. The key can also be set in hexadecimal digit.
*Enter 0X(numeral and alphabet respectively) right in front of your key code.
*Hexadecimal uses 0 to 9 and A to F.
*Up to 10 characters can be set in 64 bit and up to 26 characters in 128 bit.
NOTE: To the Mail Alert feature on wireless LAN connection, select "Infrastruc- ture" for "Mode" in "Network Type." "Test Mail" is available only when there is a LAN card in the PC card slot of the projector.
Alert Mail:
Checking this box enables Alert Mail feature.
This option notifies your computer of an error message via
Sample of a message sent from the projector:
The lamp is at the end of its usable life. Please replace the lamp.
Projector Name: X X X X
Lamp Hour Meter: xxxx [H]
Projector Usage: xxxxxx [H]
Sender's Address:
Specify the senders address. Use the Software keyboard. Up to 60 alphanumeric and symbols characters can be used. See "Using Soft- ware Keyboard" in Appendix for more details.
SMTP Server Name:
Type in the SMTP server name to be connected to the projector. Up to 60 alphanumeric characters can be used.
Recipient's Address 1 to 3:
Type in your recipient's address. Up to 60 alphanumeric and symbols characters can be used.
Test Mail:
Send a test mail to check if your settings are correct.
NOTE: If you entered an incorrect address in a test, you may not receive an Alert mail. Should this happen, check if the Recipient's Address is correctly set.
NOTE: Unless any one of the "Sender's Address", "SMTP Server's Name" or "Recipient's Address
NOTE: Be sure to highlight “OK” and press the ENTER button before execut- ing “Test Mail”.
