NEC MT1060 user manual Selecting Lamp Mode and Lamp Type Lamp Setting

[Page 5]

Remote Sensor:

This option determines which remote sensors on the projector are enabled in wireless mode.

The options are: front, rear, right, or left. All checked boxes indicate that they can accept the infrared signal from the supplied remote control.

S-Video Mode Select:

This feature is used to select the S-Video signal detection mode. This allows identifying of the S-Video signals with different aspect ratio (16:9 and 4:3).

Off	Does not identify any S-video signal.
S2	Identifies the 16:9 or 4:3 signal.

[Page 6]

Selecting Communication Speed [Communication Speed]:

This feature sets the baud rate of the PC Control port (Mini DIN 8 Pin). It supports data rates from 4800 to 38400 bps.

The default is 38400 bps. Select the appropriate baud rate for your equipment to be connected (depending on the equipment, a lower baud rate may be recommended for long cable runs).

Selecting Default Source [Default Source Select]:

You can set the projector to default to any one of its inputs each time the projector is turned on.

Last	Sets the projector to default to the previous or last
	active input each time the projector is turned on.
Auto	Searches for an active source in order of RGB1 →
	RGB2 → Video → S-Video → DVI(DIGITAL) → Viewer
	→ RGB1 and displays the first found source.
Select	Displays the selected source input every time the pro-
	jector is started up. Select an input from the pull-down
	menu.

Disabling the Cabinet Buttons [Control Panel Key Lock]:

This option turns on or off the Control Panel Key Lock function.

NOTE:

*This Control Panel Key Lock does not affect the remote control and the PC Control functions.

*When the cabinet buttons are disabled, pressing and holding the CANCEL button for about 10 seconds will change the setting to enabled.

Selecting Lamp Mode and Lamp Type [Lamp Setting]

Lamp Mode:

This feature enables you to select two brightness modes of the lamp: Normal and Eco modes. The lamp life can be extended by using the Eco mode.

Normal Mode . This is the default setting (100% Brightness).

Eco Mode	Select this mode to increase the lamp life (80% Bright-
	ness).

Lamp Type:

The lamp type you use is displayed here.

MT60LP	Standard life lamp
MT60LPS	Optional extended life lamp. When the optional ex-
	tended life lamp is used, the Lamp Mode is available.

E-46