Port link configuration
Use these commands to set port parameters for the port link.
Link commands are described in the following table. Using these commands, you can set port parameters such as speed, duplex, flow control, and negotiation mode for the port link.
The following table describes the Gigabit Link Configuration commands.
Table 77 Gigabit Link Configuration commands
Command | Description | |
speed {101001000auto} | Sets the link speed. Not all options are valid on all ports. The choices include: | |
| • | 10 Mb/s |
| • | 100 Mb/s |
| • | 1000 Mb/s |
| • “auto,” for automatic detection (default) | |
| Note: Ports | |
| Command mode: Interface port | |
duplex {fullhalfany} | Sets the operating mode. Not all options are valid on all ports. The choices | |
| include: | |
| • | |
| • | |
| • “Any,” for automatic detection (default) |
Note: Ports
Command mode: Interface port
flowcontrol {receivesendboth}
Sets the flow control. The choices include:
•Receive (rx) flow control
•Transmit (tx) flow control
•Both receive and transmit flow control (default) Command mode: Interface port
no flowcontrol | Sets the flow control to none. |
| Command mode: Interface port |
[no] auto | Enables or disables |
| Command mode: Interface port |
show interface | Displays current port parameters. |
gigabitethernet {<port | Command mode: All |
number>} |
|
Layer 2 configuration
The following table describes the Layer 2 Configuration commands. The following sections provide more detailed information and commands.
Table 78 L2 Configuration commands
Command | Description |
vlan | Enter VLAN configuration mode. |
| Command mode: Global configuration |
[no]
Enables or disables Fast Uplink Convergence, which provides rapid Spanning Tree convergence to an upstream switch during failover.
Note: When enabled, this feature increases bridge priorities to 65500 for all STGs and path cost by 3000 for all external STP ports.
Command mode: Global configuration
Configures the station update rate, in packets per second. | |
The range is | |
| Command mode: Global configuration |
show layer2 | Displays current Layer 2 parameters. |
| Command mode: All |
Configuration Commands 74