ISCLI Reference
Introduction
The 1Gb Intelligent L2 Switch is ready to perform basic switching functions right out of the box. Some of the more advanced features, however, require some administrative configuration before they can be used effectively.
The extensive switching software included in the switch provides a variety of options for accessing and configuring the switch:
•
•Simple Network Management Protocol (SNMP) support for access through network management software such as NEC WebSAM NetvisorPro
•A
The ISCLI provides a direct method for collecting switch information and performing switch configuration. Use a basic terminal to view information and statistics about the switch, and to perform any necessary configuration.
This chapter explains how to access the ISCLI to the switch.
Additional references
Additional information about installing and configuring the switch is available in the following guides, which are attached in this product.
•
•
•
•
Connecting to the switch
You can access the command line interface in one of the following ways:
•Using a console connection via the console port
•Using a Telnet connection over the network
•Using a Secure Shell (SSH) connection to securely log in over a network
Establishing a console connection
To establish a console connection with the switch, you need:
•A null modem cable with a female
•An ASCII terminal or a computer running terminal emulation software set to the parameters shown in the table below
Table 1 Console configuration parameters
Parameter | Value |
Baud Rate | 9600 |
Data Bits | 8 |
Parity | None |
Stop Bits | 1 |
Flow Control | None |
ISCLI Reference 6
