NEC R1000 manual LCD Line Key Name Assignment, + Btt

September 2003 NEC Business Solutions Ltd

LCD Line Key – Name Assignment

General Description

Use this memory block to assign a name to each LCD Line Key of the DTR-16LD-1A Telephone. Up to eight characters can be assigned.

Display

	Tel Port		Data		Line Key
	(01~CO)		No.		01~16	Title
0		1 / 6 8		: L K 0 1		N A M E
<		C O	0	1	>

Setting Data

Programming Procedures

System Mode

4

Submode

—

Data No.

68

PC Programming

+ BTT

NEW

1	Go off-line.
2	Press LK4 + FHto access the Memory Block.
3	Use the dial pad to change Line key number or name.					Default Value
	.		Use the following to enter data:			LK01~08: C0 01~08
		Jto move the cursor left
		Lto move the cursor right
		K~Ito enter Name, Line key number or Tel Port No.
			–		–
	Press	OR to go to next assigned Tel Port No.
	Press	Q			+ Ato enter A for Port Numbers 100~109.
	Press	Q			+ Bto enter B for Port Numbers 110~119.
	Press	Q			+ Cto enter C for Port Number 120.
4	Press	N to write the data and display the next Line key and name.
5	Repeat Steps 3 and 4 for each Line key assignment. After Line key 16 is programmed, the next Tel Port No. is displayed. When
	you want to program less than 16 keys, after the last Line key to program, press					R to go to next assigned Tel Port No.
	After all Tel Ports are assigned, the next memory block is displayed.
6	Program the next Memory Block or press P to go back on-line.
Related Programming
M.B. Number				Memory Block Name
7-2				Telephone Type Assignment
4-12				Line Key Selection for Telephone Mode
			1. Telephone Ports A0~C0 are ports 100~120.
N			2. The name can be entered using the dial pad. Follow the procedures in Appendix B Character Codes.
			3. The default names listed in the table below are assigned based on the line key type from Memory Block 4-12 (Line
			Key Selection for Telephone Mode)

Doc. No.: 8283 - Release 1.0 September 2003

94 – Chapter 4 LCD Line Key – Name Assignment, 4 - 68