NEC R1000 manual Trunk-to-MOH Trunk Assignment, + Bct

Xen IPK Programming

Trunk-to-MOH Trunk Assignment

General Description

Use this Memory Block to specify the music on hold source for each CO/PBX line.

Display

	CO/PBX
	No.	Data			Setting
(01~64)		No.	Title		Data
0 1		1 2 : H O L D		C O 0 0

T I M E D I S P L A Y

System Mode

3

Submode

—

Data No.

12

PC Programming

+ BCT

Programming Procedures

	1	Go off-line.
	2	Press LK3 +		N +ABaccess the Memory Block.
	3	Enter data for CO/PBX No. using the dial pad to assign the music selection.			Default Values
		.	Use the following to enter data:		00 = Not Assigned for CO/PBX No. 01~64
			Jto move the cursor left
			Lto move the cursor right
			K~Ito enter numeric data or CO/PBX No.
			–	–
			OR to go to the next assigned CO/PBX No.
	4	Press	N to write the data and display the next Memory Block.
	5	Program the next Memory Block or press P to go back on-line.
	Related Programming
	M.B. Number			Memory Block Name
	1-4-17			Automated Attendant Delay Announcement Hold Tone Selection
	1-8-09			Music on Hold Pattern Selection
	1-8-31			Hold Tone Source Assignment
	1-8-32			Hold Internal Tone Volume Selection
1.0	3-11			CO External Source Selection
Release-8283No.:Doc. 2003September	4-66			MOH or Ring Back Tone Selection

3 -12, Trunk-to-MOH Trunk Assignment Chapter 4 – 89