NEC VT45 user manual Terminal Panel Features

Terminal Panel Features

7 4 5 2 8

	AUDIO			PC
S-VIDEO			RGB OUT	CONTROL
IN	L/MONO	OUT
	IN
VIDEO
IN	R IN	IN	RGB IN

63 1

1.RGB Input Connector(Mini D-Sub 15 pin)

Connect your PC or other RGB equipment. Use the supplied signal cable to connect to a PC.

2.RGB Monitor Output Connector (Mini D-Sub 15 pin)

You can use this connector to loop your computer image to an external monitor from the RGB input source.

3.Audio Input (Mini Jack)

This is where you connect audio output from your computer.

4.Audio Input (RCA)

This is where you connect audio output from a VCR, DVD player, or laser disc player.

5.Audio Output (Mini Jack)

Connect audio equipment to this jack. Note that this cannot be used as a headphone jack.

(When audio equipment is connected, the projector speaker is disabled.)

When a cable mini-plug is inserted into this jack, both the right and left audio signals are not mixed, but separate.

For example, when a cable mini-plug is inserted into the left AUDIO IN jack only, only left sound is output.

NOTE1: ON AUDIO IN/OUT

The audio input (mini jack) 3 is available for RGB source only. The audio input (RCA) 4 is available for Video or S-Video source only.

The audio output (mini jack) 5 operates when audio source 3 or 4 is selected.

NOTE2: During Stand by Condition

RGB signal will be sent to the connected external monitor. Audio signal will not be sent to the audio output.

E

AC IN

6.Video Input (RCA)

Connect a VCR, DVD player, laser disc player, or document camera here to project video.

7.S-Video Input Port (Mini DIN 4 Pin)

Connect the S-Video input from an external source like a VCR.

8.PC Control Port (Mini DIN 8 Pin)

Use this port to connect your PC to control your projector. This enables you to use your PC and serial communication protocol to control the projector. If you are writing your own program, typical PC control codes are on page E-43.

E–11