Regulatory Information
Austel Requirements (Australia Only)
The software supplied with this modem has default settings compliant with the requirements of Austel Technical Standard
Adjustment of these settings outside the required limits will void the Austel permit associated with the modem.
Dial Retry Attempts
With the service tone detection enabled (eg. Busy Tone) the unit must not be configured to make more than 1Ø dial attempts to the same telephone number.
With the service tone detection disabled (eg. Busy Tone - ATXØ) the unit must not be configured to make more than 3 dial attempts to the same telephone number.
With dial tone detection disabled (eg. ATXØ) the unit should be configured to dial not less than two seconds after line seizure and not more than 5 seconds after line seizure.
In all of the above cases no further attempts shall be made to connect to the telephone number, until a further period of at least 3Ø minutes has elapsed (this does not apply if the redial sequence is manually restarted).
Call Answering
The modem shall answer an incoming call by seizing the line in not less than 2 seconds from the start of the application of ring signal from the PSTN. (eg. ATSØ=2 or issue ATA after the 2nd ring.)
Internal Modems Internal modems are designed to operate only within a PC with a screw down lid.
Also, telecommunications network voltages exist on the card inside the PC. Therefore the
telecommunications line connection (Telecom cable) must be removed before opening the case of the PC. NOTE Adjustment of these settings outside the required limits will void the Austel permit associated with the modem.
Connection of a
www.netcomm.com.au | Rev.1 - YML658 |
Page 32 | AM5698 Roadster V.92 User Guide |
