Before continuing, ensure you have the following items and information ready:
■A computer with a Network Interface Card installed or a router (such as the NetComm NB3100).
■A USB cable.
■A telephone line with ADSL service enabled.
■User Name, Password, VPI, VCI, encapsulation and DNS server settings for your ADSL account (ask your ISP if unsure). These are not needed for the NB1300Plus4, but are required for the computer or router that it will be connected to.
Note: The following procedure presumes your NB1300Plus4 is set to a factory default IP address 192.168.1.1.
Step 1: Connecting your computer to the NB1300Plus4
Note: This unit should only be connected to the Telecommunications Network through a line cord which meets the requirements of ACA TS008.
a. Place the
b.Connect the USB cable from the NB1300Plus4 into a spare USB port on your computer. If you are using Macintosh OSX, please refer to the Macintosh USB Configuration section on page 34.
c.Windows will detect the new hardware and launch a New hardware Wizard. When prompted to search for drivers choose “Specify location”.
d.Browse the drive letter of your
e.Continue with the driver search by clicking OK and the Found Hardware Wizard will locate the USB driver and prompt you to install it.
f.Once the driver is installed, it is configurable as a regular Ethernet adapter and will be set to automatically accept an IP address from the NB1300Plus4. You can manually set its IP address to any free address in the range of 192.168.1.2
Note: When the NB1300Plus4 is used in Bridge mode it is a fairly passive device and most Internet configuration required (such as User Name, Password, etc.) is done on the computer or another router.
Rev. 1 - YML674 | www.netcomm.com.au |
NB1300Plus4 ADSL Modem | Page 19 |
