
Figure 2. Mount the Switch in the rack
Connecting Network Cable
The Switch supports 1000Mbps Gigabit Ethernet that runs in
☞Important Note:
Some Category 5 cables are only prepared with two pairs (4 wires) of interconnection wires which are not suitable for Gigabit Ethernet over Category 5 cables.
In order to use the full performance of this switch in Gigabit mode, please ensure that your cabling uses four pairs (8 wires). The switch’s
AC Power
The Switch uses AC power 240V AC, 50 Hz. The power switch is located at the rear of the unit adjacent to the AC power connector and the system fan. The Switch may be turned on without having any or all LAN segment cables connected.
NetComm 16 or 24 port Gigabit Switch | YML711 Rev1 |
10 | www.netcomm.com.au |