Appendix B: Cable Connections

This cable information is provided for your reference only. Please ensure you only connect the appropriate cable into the correct socket on either this product or your computer.

If you are unsure about which cable to use or which socket to connect it to, please refer to the hardware installation section in this manual. If you are still not sure about cable connections, please contact a professional computer technician or NetComm for further advice.

RJ-45 Ethernet Network ports

For 10BASE-T/100BASE-TX/1000BASE-T (10/100/1000BASE) connections, a twisted pair cable with four pairs (8 wires) and RJ-45 connectors must be used.

Caution: Do not plug a phone jack into any RJ-45 port. Doing so could damage the switch. Use only twisted pair cables with RJ-45 connectors.

RJ-45 plug attached to cable

For twisted pair cables each pair is identified by two different colours. For example, one wire might be red, and the other red with a white stripe. An RJ-45 connector must be fitted to both ends of the cable.

Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as prescribed.

10Mbps:

Use EIA/TIA-568-100-Category 3, 4 or 5 cable.

100Mbps:

Use EIA/TIA-568-100-Category 5 cable.

1000Mbps:

Use EIA/TIA-568-100-Category 5e cable.

The 1000Base-T Gigabit Ethernet standard uses all four pairs of the Cat 5e cable. Each pair is used to transmit and receive data simultaneously, known as Dual-Duplex transmission. Basically, this is a technique where it is possible to distinguish the direction a signal is travelling.

Cat 5e cable is an enhanced version of Cat 5 for use with 1000 Base-T networks, or for long-distance 100 Base-T links (350 m, compared with 100 m for Cat5). It must meet the EIA/TIA 568A-5 specification.

 

Note:

To prevent loss of signal, make sure that the length of any twisted-pair

 

 

 

connection does not exceed 100 meters.

 

 

 

 

 

YML711 Rev1

NetComm 16 or 24 port Gigabit Switch

www.netcomm.com.au

37

Page 37
Image 37
NetComm NP3024 manual Appendix B Cable Connections, RJ-45 Ethernet Network ports