Restore Factory Default | NETGEAR WAB102 specs

User’s Guide for the WAB102 802.11a+b Dual Band Wireless Access Point

Restore Factory Default

To restore factory default settings, complete the following:

1.Choose the Restore Factory Default option from the AP Setup menu on the WAB102 Web Server home page.

2.Select the Yes option.

3.Click Apply and then the Reboot button for the changes to take effect.

30	Setting Up Basic Wireless Connectivity

Image 33

NETGEAR WAB102 manual Restore Factory Default

Contents

NETGEAR, Inc Technical Support Contents Chapter Introduction About the Wireless Access Point Benefits Features WAB102 Dual Band System Requirements Compatible and Related Netgear Products What’s In the Box? Hardware Description 802.11a+b Standards-based Wireless Networking Following table explains the LED indicators WAB102 Wireless Access Point Front Panel Restore to Factory Default Button WAB102 Wireless Access Point Rear Panel Setting Up Basic Wireless Connectivity What You Will Need Before You Begin Placement and Range Guidelines Installation Overview Install the WAB102 Wireless Access PointCabling Requirements Wireless Verify the installation was successful Default Factory Settings DisabledAuthentication Type Open System Determine the name of your access point Basic Configuration Configure Basic Setup Parameters Log In to the Access Point For LAN parameters, see TCP/IP Configuration Parameters on Default Default gatewayDefault Enable IP Address Default Wireless Ssid Service Set IDTurbo Mode Default Disable 802.11b Wireless LAN Configuration Parameters Change Password Security Configuration For 64-bits encryption Default Key Authentication TypeDefault key size 64 bits Key Size Key 1 802.11b Wireless LAN Security Parameters Access Control Access Control Firmware UpgradeAccess Control List MAC Address Advanced Setup Default100% Transmit PowerBeacon Interval RTS Threshold Preamble Type Default Long Restore Factory Default AP Status Station List About Setting Up Basic Wireless Connectivity Enabling Basic Wireless Access Security Features Protecting Your Wireless Network Change the Password Secure the Access PointBefore You Change the Ssid and WEP Settings Authentication Change the Ssid Configure WEP Encryption Restrict Wireless Activity by MAC Address Protecting Your Wireless Network Basic Functioning No lights are lit on the access point Ethernet Link/Act light is not lit One or both of the wireless activity lights do not light up Troubleshooting Compliance Regulatory Compliance Information NETGEAR, Inc