ProSafe 5 AP Wireless Management Software WMS105
•Trap Port: The default port on which SNMP manager receives traps sent from the Wireless Management Software is 162.
•SNMP Manager IP: Restrict access to specified SNMP manager for doing SNMP v1/v2. Set this as 255.255.255.255 to allow any SNMP manager to access.
When you are finished making changes, click Apply to save your settings.
Remote Management
You can enable SSH or Telnet to remotely log in to the controller. From the Maintenance tab select Remote Management > System > Remote Console:
1.Select the radio button for SSH or Telnet:
•Secure Shell (SSH): If set to Enable, the Wireless Management Software allows remote access by using Secure Shell.
•Telnet: If set to Enable, the Wireless Management Software allows remote access by using Telnet.
2.Click Apply to save your settings.
Upgrading Access Point Firmware
You can install a new firmware for the access points using the Access Point Upgrade page.
WARNING!
In some cases, such as a major upgrade, you might need to erase the configuration of your access point after upgrading it.
See the Release Notes included with the software to find out if you need to reconfigure the access point. Reconfiguring access points already managed by the Wireless Management Software requires only the IP address to be set manually. The Wireless Management Software restores configuration for already managed access points running supported software version.
32 Chapter 6: Maintenance
