Nikon 4300 manual 16 After Successfully Adding a Device to the Mesh

Chapter 3: Device Configuration

23

A successfully configured device will display the same information in the entry fields and check boxes that were intended when configuring the device. Incorrectly displayed entry fields or check boxes will be a sign of a failed device configuration.

You can also check the progress log for the following characteristics:

-802.11 a radio status enabled

-802.11 a mesh status enabled

-Probe found DHCP IP addressing

-Successfully wrote 802.11 a ….

-Successfully wrote License Key xxxxxxxxxx (newly added license key #)

-Successfully wrote VLAN Membership xxxxxxxxx (newly added license key #)

-Completed writing device name to subcomponents.

Figure 3-16 After Successfully Adding a Device to the Mesh

24

If any errors are detected, you should delete the device from the Device Tree and start over with the specific device.

To delete a device, right-click on it in MeshManager’s Device Tree, and then select Delete Device from the pop-up menu.

25

End of Procedure.

July 2007

3-12