Nikon P7800, 26427, COOLPIXP7800BK Troubleshooting, Power, Display, Settings Issues

Troubleshooting

If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative.

Power, Display, Settings Issues

	Problem		Cause/Solution	A
		•	Wait for recording to end.	–
		•	If the problem persists, turn the camera off. If the	26,
			camera does not turn off, remove and reinsert the	E104
	The camera is on		battery or batteries or, if you are using an AC adapter,
	but does not		disconnect and reconnect the AC adapter.
	respond.		Note that although any data currently being
			recorded will be lost, data that have already been
			recorded will not be affected by removing or
			disconnecting the power source.
	Camera cannot	•	The battery is exhausted.	26
		•	The camera cannot be turned on if the battery-	22
	be turned on.
			chamber/memory card slot cover is open.
		•	The camera automatically turns off to save power	27
Technical		•	(auto off function).
	Camera turns off		The camera or battery have become too cold and	F3
	without	•	cannot operate properly.
	warning.		The inside of the camera has become hot. Leave the	–
Notes			camera off until the inside of the camera has cooled,
			and then try turning it on again.
and
		•	The camera is off.	26
Index		•	The battery is exhausted.	26
		•	The camera has entered standby mode to save	27
			power. Press the power switch, shutter-release
	The monitor or	•	button or cbutton, or rotate the mode dial.
			You cannot turn on both the monitor and viewfinder	–
	viewfinder is		at the same time. It may take a while to switch
	blank.	•	between the monitor and viewfinder.
			The camera and computer are connected via a USB	102,
		•	cable.	106
			The camera and TV are connected via an audio video	102,
		•	cable or HDMI cable.	E18
			Interval timer shooting in progress.	E47

F8