Nikon COOLPIXS60RED, COOLPIXS60PNK Troubleshooting, Display, Settings and Power Supply, 159

Troubleshooting

If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative. Refer to the page numbers in the right-most column for more information.

Display, Settings and Power Supply

Problem		Cause/Solution	A
Monitor is blank	•	Camera is off.	22
	•	Battery is exhausted.	22
	• Standby mode for saving power: press the		17, 26
		shutter-release button halfway.
	• Camera and computer are connected via USB		102
		cable.
	• Time lapse or interval timer photography in		–
		progress.
Monitor is hard to read	•	Adjust monitor brightness.	139
	• Monitor is dirty. Clean monitor.		154
Camera turns off without	•	Battery is low.	22
warning	• Camera has turned off automatically to save		144
	•	power.
		Battery is cold.	153
Date and time of recording are	• Pictures recorded before clock was set, and		18
not correct		“Date not set” indicator blinks during shooting,
		will have time stamp of “00/00/0000 00:00”;		Technical
		movies and voice recordings will be dated “01/
		01/2008 00:00.” Set the correct time and date
		from the Date option in the setup menu.		Notes
	• Check camera clock regularly against more		136
		accurate timepieces and reset as required.
No indicators displayed in	Hide info is selected for Photo info.		139
monitor	Select Show info.
Date imprint not available	Camera clock has not been set.		18, 136
Date not appearing on pictures	Date does not appear on movies or on pictures		38, 41,
even when Date imprint is	taken using d(Sports), l(Museum), p		42, 87,
enabled	(Panorama assist) or when the Continuous		121
	setting is set to Continuous or BSS.
Camera settings reset	Backup battery is exhausted; all settings were		137
	restored to their default values.

159