INSTALLATION AND CONNECTIONS

To connect SCART output (RGB)

Before connections: An exclusive SCART adapter (ADP-SC1) and a commercially available SCART cable are required for this connection.

NOTE: Audio signal is not available for this connection.

Projector

Video equipment such as DVD player

COMPUTER

AC IN

AUDIO IN S-VIDEO IN VIDEO IN

COMPUTER

 

 

To COMPUTER connector

Commercially available

Female

ADP-SC1

SCART cable

 

 

1.Turn off the power to the projector and your video equipment.

2.Use the NEC ADP-SC1 SCART adapter and a commercially available SCART cable to connect the COMPUTER input of your projector and a SCART output (RGB) of your video equipment.

3.Turn on the power to the projector and your video equipment.

4.Use the COMPUTER button on the remote control to select the COM- PUTER input.

5.Press the MENU button on the remote control to display the menu.

6.From the menu, select [To Advanced Menu] [Setup 2] [Signal Select Computer] [Scart].

SCART is a standard European audio-visual connector for TVs, VCRs and DVD players. It is also referred to as Euro-connector.

NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Eu- rope. Contact your NEC dealer in Europe for more information.

Using the projector in portrait mode

When connecting with a Tablet PC, you can display an image in portrait mode with the projector on its side.

Place the projector on a location such as a table with the terminal panel side up.

Be sure to place the projector on a flat level surface.

Auto Keystone correction feature is not available.

The on-screen menu will not be rotated.

• If the image is displayed upside down, select [Advanced menu] [Setup 1] [Portrait] [0°] or [180°] for display orientation of your PC. See also page E-33 for Portrait.

The projected image is displayed at a lower level than the normal position. Adjust the projection angle and position for the correct position of the projected image on screen.

E-13

Page 13
Image 13
Nikon LT170 manual To connect Scart output RGB, Using the projector in portrait mode