MACHINE PREPARATION

3)Push machine down the ramp onto a flat surface.

4)Install battery.

-Turn the key to the “O” position

-Lift the hood up and pull the battery lever up to the right.

-Use a battery lifting device with a 2000 LB. (907KG) capacity to place the battery into the battery tray. -Push battery lever down to the left to lock the battery into place.

-Plug the battery power connector into the machine power connector. -Lower the hood into place.

5)Charge battery as shown in the manual. Read battery manufacturer literature for battery care and maintenance.

WARNING

Do not charge batteries on a concrete grounded surface. Hydrogen gas is formed during the charging operation and is explosive. Only charge batteries in a well ventilated area with the lid open. Avoid any smoking, open flame, or electrical sparks.

USE A 2000 LB. (907 KG) LIFTING DEVICE TO INSTALL BATTERY

Fig 3

Fig 4

UNPACKING BATTERY

The battery is shipped separately on a pallet wrapped in plastic as shown in figure 3. Remove the plastic and use a 2000 LB. (907KG) capacity lifting device to lower the battery into the battery compartment as shown in figure 4.

1-18

AMERICAN-LINCOLN

 

SMART

Page 18
Image 18
Nilfisk-ALTO 692003 manual Unpacking Battery