Installation of the Mediamaster
The Mediamaster box should contain the following items:
•the Mediamaster
•a remote control with 2 AAA batteries
•a SCART cable (fully connected 1.0 metre)
• a mains cable
• an owner’s manual with the software license agreement
SCART | Mains | Remote | Owner’s |
cable | cable | control | manual |
About the SCART sockets
The rear panel of the Mediamaster contains 2 SCART sockets |
|
(see diagram). When you connect other devices to any of these |
|
sockets, always use fully connected SCART cables (as supplied). |
|
There are “less well specified” SCART cables on the market and |
|
picture quality could be reduced if they are used. | SCART socket |
|
Preparing the remote control
•Remove the cover from the battery compartment at the bot- tom of the remote control.
•Insert the 2 AAA (1.5 V) batteries, as shown in the diagram. Make sure that you observe the + and - markings indicated inside.
•Replace the cover.
Connecting the Mediamaster to the dish
If you need to fit the F-connectors onto the cable
•Prepare each end of the cable as shown in the diagram. You will need to fold back the outer braid (as shown).
•Slide the
•Ensure that 3 mm of the core is protruding from the end of the connector.
Installing the satellite dish
•See the Fitting instructions provided with your satellite dish on how to install the dish.
•Connect the coaxial cable, with the
General
There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster.
In this manual, you will see some of the most common ways to connect your equipment.
If you have problems with your connections and need help, please contact your dealer.
GB 14
15 mm
8 mm
3 mm
