Keywordreference
XFAX- User’s Guide 4.3a 54
Indicatesthat client programs should be quiet and not write information onto the
screenas standard. For example this is equal to calling faxsend with the argu-
ment -q.
15.1.67 RECEIVE_ONLY
RECEIVE_ONLY
Indicatesthat fax lines should be used only for receiving. This function is also
controlledby the scope of your license agreement. If the fax modem is used for
incomingmodem traffic and outgoing fax traffic SEND_ONLY must be given,
otherwisethe fax server will try to answer and receive incoming calls as a fax.
15.1.68 RESOLUTION
RESOLUTION=HIGH | LOW
Gives the standardresolution of the faxes that are sent out. Note that if the fax
calleddoes not support high resolution then low resolution is negotiated. Possi-
ble valuesare HIGH or FINE for high resolution and LOW or STANDARD for
low resolution.
Ahigh-resolution fax is precisely twice as large asa low-resolution fax and takes
twice aslong to send (approx. 1 minute for an A4 page).Standard value: HIGH
(high resolution)
15.1.69 RETRY_TIME
RETRY_TIME=minutes
Indicatesat what minute intervals attempts should be made to send a fax that is
not successfullysent.
15.1.70 REVERSE_STATS
REVERSE_STATS
Indicatesthat statistics lists (sent and failed faxes) should be shown in reverse
order,i.e. with the most recent fax first.
15.1.71 ROUND_ROBIN
ROUND_ROBIN
When using multiplefax devices with XFAX the standard behavior is to always
usethe first available line for transmission so if FAXLINES=tty00:tty01,tty00 is
always pickedif available. By using this keyword fax lines are always used in
sequentialorder. That is, first tty00 is used then tty01, tty00 andso on. This is
reallythe best way to minimize non-successful attempts if a fax device should
break down.
15.1.72 SEND_BPS
SEND_BPS