P REVENTIVE | M AINTENANCE |
Regular maintenance is necessary for optimal performance and long treadmill life. Please read and follow all instructions below. If the treadmill is not maintained as described, components may wear excessively,
the treadmill may be damaged, and the warranty will be voided.If you have questions about maintenance, call Customer Care
holidays). CAUTION: Make sure to remove the key and unplug the power cord before performing any main- tenance procedures.
WEEKLY MAINTENANCE
1.Inspect and properly tighten all external parts of the treadmill.
2.Apply a mild
ing belt. | Do not wipe under the walking belt. | Apply a small amount of mild | |
cotton cloth and wipe | the console and the screens. | Do not spray cleaner directly onto the treadmill or use | |
ammonia or | cleaners. |
| |
3.Make sure that the walking belt is centered and properly tightened. If it is centered and runs smoothly, do not make any adjustments. If the walking belt needs to be adjusted, refer to pages 33 and 34.
MONTHLY MAINTENANCE
1. Remove the two screws attaching the motor hood and lift off |
| ||
the motor hood. Using a | Motor | ||
covered by the motor hood. | Be careful to avoid touching | ||
Belt | |||
any components. |
| ||
|
| ||
2.Check the motor belt for wear and cracks. If the motor belt needs to be replaced, refer to page 44 to order a new motor
belt. |
|
|
|
3. Plug in the power cord and insert the key into the console. |
|
| |
Press the START button. | Be careful to avoid injury; keep |
|
|
your hands away from moving parts and make sure that |
|
| |
your clothing cannot become caught in moving parts. | While the walking belt is moving, check the motor | ||
for arcing. Next, check the treadmill for unusual noises or odors. If any of these problems exists, call Customer |
| ||
Care | Remove the key and unplug the power cord. | Reattach the motor hood with | |
the two screws. |
|
|
|
4. The walking platform should | not be lubricated before the |
|
|
treadmill is used. However, lubricant should be applied at |
|
| |
least once per month. To purchase a lubricant pump or lubri- |
|
| |
cant packets, call Customer Care |
|
| |
CAUTION: Before applying lubricant, remove the key and |
|
| |
unplug the power cord. |
|
|
|
To use a lubricant pump, | first prime the pump. Insert the |
|
|
| A | ||
wand under the walking belt in the location shown by dotted |
|
| |
|
| ||
line A. Center the nozzles under the walking belt and apply |
|
| |
lubricant as you slide the wand forward to dotted line B. Then, |
|
| |
pull the wand back out. | To use lubricant packets, | open one | |
packet, reach under one side of the walking belt as far as you can, and apply the entire packet between dotted line A and
dotted line B. Then, apply a second packet under the other side of the walking belt in the same way. have applied lubricant using a lubricant pump or lubricant packets, plug in the power cord, insert the key, adjust the speed to 3 mph, and walk on the walking belt for two minutes to spread the lubricant.
B
Apply packet here
Insert wand here
After you
29
