TURNING THE WALKING PLATFORM
Both sides of the walking platform are designed to be used as walking surfaces. Inspect the walking platform peri- odically for wear. If there is any wood showing through the phenolic coating, or if the surface is damaged, the walking platform should be turned over. The walking platform will need to be turned over after every 6,000 to 7,500 miles. Follow the instructions below to turn over the walking platform.
1.Remove the key and unplug the
power cord. | Remove the two |
| 1 | 2 | |
|
| ||||
Hood Screws (2) and lift off the |
|
|
|
| |
Motor Hood (1). Next, remove the |
|
|
|
| |
two Rear Roller Bolts (82), the |
| 80 |
|
| |
two Roller Guard Screws (80), |
|
| 6 | ||
83 | 6 |
| |||
and the Right and Left Roller |
|
| |||
|
|
|
| ||
Guards (81, 83). |
| 82 |
|
| 70 |
|
|
|
| ||
|
|
|
| 80 | |
2. Remove the six Platform Screws |
|
|
| ||
|
|
|
| ||
(6).(Note: Be very careful when |
| 81 | 6 |
| |
removing the Platform Screws |
| 82 |
|
| |
and when handling the Walking |
|
|
| ||
|
|
|
| ||
Platform [70]. The phenolic |
| 71 |
|
| |
coating on the Walking |
|
|
| ||
| 79 |
|
| ||
Platform can be chipped or |
|
|
| ||
damaged if it is mishandled.) |
|
|
|
| |
Lift the Rear Roller (79) and slide |
|
|
|
| |
it out of the Walking Belt (71). Lift |
|
|
|
| |
the Walking Platform (70) a few inches, slide it out of the Walking Belt, turn it over, and then slide it back into the Walking Belt. Slide the Rear Roller back into the Walking Belt. Reattach the six Platform Screws (6).
3.Reattach the Right and Left Roller Guards (81, 83) with the two Roller Guard Screws (80). Insert the Rear Roller Bolts (82) into the Roller Guards and thread them into the Rear Roller (79). Reattach the Motor Hood
(1)with the two Hood Screws (2).
4.Next, the Walking Belt (71) will need to be adjusted to the proper tension. Using chalk, make two marks on the Walking Belt exactly 50” apart, as shown in the drawing. Tighten both Rear Roller Bolts (82) until the two chalk marks move apart an additional 3/16” to 1/4”. Make sure to keep the Walking Belt centered.
REPLACING THE WALKING PLATFORM
4 | 71 |
| |
| 50” |
82 |
|
When both sides of the walking platform become worn, the walking platform should be replaced. The walking |
|
| |
platform will need to be replaced after every 12,000 to 15,000 miles. Refe | r to page 44 to order | a new walking plat- | |
form. Follow the instructions above to replace the walking platform. |
|
| |
REPLACING THE WALKING BELT |
|
|
|
When the walking belt becomes worn, it should be replaced. The walking belt will need to be replaced after every |
|
| |
12,000 to 15,000 miles. Refe | r to page 44 to order a new walking belt. |
|
|
30
