Installing the mounting brackets on the chassis 31
CAUTION
ESD
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap connected to an electrostatic discharge (ESD) jack when performing maintenance on this product. Ensure that the wrist strap makes contact with your skin.
CAUTION
ACHTUNG
ESD
Um Schäden durch elektrostatische Entladung zu verhindern, tragen Sie bei der Instandhaltung dieses Produkts immer ein antistatisches Band am Handgelenk, das mit einer
Prerequisites
•Ensure you have the power supply module for the Secure Router 4134.
•Ensure you have a Phillips #2 screwdriver.
Procedure steps
Step Action
1Using a Phillips screwdriver, loosen the two screws that secure the metal plate that covers the slot in which you want to install the power supply unit.
2Remove the cover plate.
3Insert the power supply module in the power supply slot.
4Push the power supply module gently, but firmly, to insert it fully into the internal connection port.
When the power supply is fully inserted, the front of the power supply module is flush with the rear panel of the router.
5Secure the power supply in the chassis by tightening the two retaining screws.
Installing the mounting brackets on the chassis
You must install the mounting brackets on the Secure Router 4134 before installing the chassis in an equipment rack. You can mount the Secure Router 4134 with either the front panel or the back panel facing the operator. The following table shows the six possible mounting positions.
Nortel Secure Router 4134
Quick Start
18 February 2008
