56Configuring the Secure Router 4134 for remote access

Prerequisites

Ensure you have the supplied console cable.

Ensure you have the supplied female DB-9 to RJ-45 adapter if you require it for connection to your terminal or PC.

Ensure you have the Secure Router 4134 securely installed in the equipment rack.

Ensure you have powered up the terminal or PC.

Procedure steps

Step Action

1Set the terminal protocol as follows: a 9600 baud

b 8 data bits c 1 stop bit d no parity

e flow control: None

2Insert the male RJ-45 connector in the console port on the rear panel of the Secure Router 4134.

3Connect the female DB-9 to RJ-45 adapter to the opposite end of the console cable, if necessary.

4Insert the RJ-45 or female DB-9 connector (dependent on your equipment) in a terminal or PC.

5Power up the Secure Router 4134.

--End--

Establishing remote access

The first time you log on to the Secure Router 4134 CLI, you perform initial configuration such as the following:

1.Configure the IP address for the management port.

2.Configure the next hop (gateway IP address).

3.Verify a successful connection.

4.Enable remote access.

You can enable SSH or Telnet for remote connections.

Nortel Secure Router 4134

Quick Start

NN47263-100 02.01 Standard

18 February 2008

Copyright © 2007, 2008 Nortel Networks

Page 56
Image 56
Nortel Networks 4134 quick start Establishing remote access, Prerequisites