52Installing the Secure Router 4134 chassis and hardware components

Powering up the router

Use the procedure in this section to power up your Secure Router 4134.

Prerequisites

Ensure all installation procedures are complete.

Ensure an operator console is connected to the Secure Router 4134.

Ensure the Secure Router 4134 is connected to a power source.

Procedure steps

Step Action

1For an AC power supply, press the rocker switch located on the power supply to the on position ( ).

2On a DC power supply, ensure the DC power source is on.

3Verify that the power supply status LED for each power supply is green.

4Verify that the fan status LED is green.

5Verify that the air flows from the cooling fans through the vents of the chassis.

The fan tray red (fail) LED can illuminate briefly while the fans power to operational speed.

--End--

If status LEDs do not illuminate green, see Nortel Secure Router 4134 — Troubleshooting (NN47263-700).

Verifying a successful installation

Use the information in this section to verify that you have successfully installed the Secure Router 4134 and its components.

If any LED behavior indicates failure or is suspect, see Nortel Secure

Router 4134 — Troubleshooting (NN47263-700).

In a normal power-up sequence, the following events occur:

1.When you power up the router, the fans start and the Secure Router 4134 performs a self-test.

2.At the successful conclusion of the self-test sequence, LED activity begins. The following table describes LED behavior at power-up.

Nortel Secure Router 4134

Quick Start

NN47263-100 02.01 Standard

18 February 2008

Copyright © 2007, 2008 Nortel Networks

Page 52
Image 52
Nortel Networks 4134 quick start Powering up the router, Verifying a successful installation