AT commands
Use the following types of AT commands to communicate with your CTA 500dm.
¥ProÞle commands
¥State commands
¥General commands
¥
¥Call Control commands
¥TCM Ports Protocol Selection commands
¥MP commands
¥Serial Interface commands
¥Serial Interface Control Lines commands
¥Calling Line ID commands
¥Caller ID Security commands
To use an AT command, establish a HyperTerminal connection from the PC to the CTA 500dm. Type the letters AT followed by the desired AT command. For instance, the AT&V0 command queries all stored CTA 500dm parameters.
You can string several AT commands into a single entry (for example, AT &V0 S26 I4). The individual AT commands within the string do not have to be separated by spaces (AT&V0S26I4 provides the same information as the separated string in the previous example).
P0873832 Issue 05 | CTA 500dm On Line Guide |