AT commands 57
Serial Interface Control Lines commands summary
Command | Description | Value | |
|
|
|
|
\Qn | serial interface | 0 | none |
| flow control | 1 | bidirectional XON/XOFF |
|
| ||
|
| 2 | not supported |
|
| 3 | bidirectional RTS/CTS |
|
|
| (default) |
|
| 4 | not supported |
|
|
|
|
&Cn | DCD operation | 0 | always on |
|
| 1 | tracks connection (default) |
|
| 2 | always on, except temporarily |
|
|
| after disconnect |
|
|
|
|
&Dn | DTR operation | 0 | ignored (default) |
|
| 1 | enter command state |
|
| 2 | |
|
|
| while DTR is down |
|
| 3 | |
|
|
|
|
&Rn | CTS operation | 0 | CTS follows RTS |
|
| 1 | CTS is always on when |
|
|
| (default) |
|
|
|
|
&Sn | DSR operation | 0 | DSR is always on (default) |
|
|
|
|
Flow Control
The Flow Control Command
\Qvalue
sets the method of ßow control on the interface between the
CTA 500dm and the attached computer. The following table shows the allowable values.
Value | Use |
|
|
0 | disable flow control |
|
|
1 | enable bidirectional XON/XOFF software flow control |
|
|
2 | not supported |
|
|
3 | enable bidirectional RTS/CTS hardware flow control (default) |
|
|
P0873832 Issue 05 | CTA 500dm On Line Guide |