Nortel Networks FC9219 - FC9200 English, Electromagnetic fields EMF, Preparing for use, Hose

English

-Never use the appliance without the motor protection filter.This damages the motor and shortens the life of the appliance.

-Only use the Philips filter cylinder supplied with the appliance.

-Noise level: Lc = 76 dB(A).

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientific evidence available today.

Preparing for use

Hose

1To connect the hose, push it firmly into the appliance (‘click’) (Fig. 2).

2To disconnect the hose, press the release button and pull the hose out of the appliance (Fig. 3).

Telescopic tube

1To connect the tube to the handgrip of the hose, press the spring-loaded lock button on the handgrip and insert the handgrip into the tube. Fit the spring-loaded lock button into the opening in the tube (‘click’) (Fig. 4).

2To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the handgrip out of the tube.

Use the same method to connect and disconnect the nozzles.

3Adjust the tube to the length you find most comfortable during vacuum cleaning (Fig. 5).

Tri-Active nozzle

The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors.

-The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean better along furniture and other obstacles (Fig. 6).

-The opening at the front of the nozzle allows you to suck up larger particles (Fig. 7).

1To clean hard floors, push the rocker switch on top of the nozzle with your foot (Fig. 8). , The brush strip for cleaning hard floors comes out of the housing.At the same time, the

wheel is lifted to prevent scratching and to increase manoeuvrability.

2To clean carpets, push the rocker switch again (Fig. 9).

,The brush strip disappears into the nozzle housing and the wheel is lowered automatically.

Crevice tool, small nozzle and small brush

1Connect the crevice tool (1), the small nozzle (specific types only) (2) or the small brush (3) directly to the handgrip or to the tube (Fig. 10).

Accessory holder

1Snap the accessory holder onto the handgrip (Fig. 11).

2Snap two accessories into the accessory holder:

-Crevice tool and small nozzle (Fig. 12).

Note: Make sure the suction opening of the small nozzle points away from the holder.

-Crevice tool and small brush (Fig. 13).

Note: Make sure the suction opening of the small brush points towards the holder.

4222.003.3090.4.indd 7

22-11-2007 10:20:06